……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
1
………………………………………………………….…
G
la
s
S
ti
le
G
L
S
GlasStile GLS
Motorised Low Height, Security Entrance Gate for Internal Installation
Drive
:
Motorised
Orientation
:
Pass Left or Pass Right
Materials
:
•
Type A -
Material 304 Grade Grained Stainless Steel.
63mm dia. uprights and 38mm dia handrail.
•
Type B -
Material 304 Grade Polished Stainless Steel.
50mm dia. uprights and handrail.
•
Type D -
Material 304 Grade Grained Stainless Steel.
63mm dia. uprights with handrail material choice
and 10mm curved toughened glass.
Rotor Column:
220mm dia 304 Grade Grained Stainless
Steel (EN 10088-2 Grade 1J/2J).
Rotor Wing:
3N
O
10mm thick clear toughened frameless
glass panels
Diameter:
1350mm or 1500mm
Function
:
Passage in both directions, electronically controllable.
Method of Operation
:
On receiving a signal from the access control system or pushbutton,
the unit will unlock and be in a state of readiness for use. On the
paddle receiving pressure from the user i.e. push to start, the motor will
take over and drive 120
O
to its next home position. Should the wing
meet any resistance it will stop and nudge forward. If obstruction
continues the unit will alarm and free wheel. An Auto-Reset will re-
establish control. Should an attempt be made to tailgate the unit will
lock. The Auto Reset will re-establish control..
Power Failure
:
In the event of an emergency or isolation of power supply, unit will fail-
safe i.e. rotor would freely turn in both directions.
•
Fire Alarm – Input facility available for voltage free contact
supplied by others to effect fail safe state.
Interface
:
Potential-free contact provided by either a cardreader or pushbutton
input. Cardreader inhibit and reset output signals available as
standard.
The unit has an adjustable time out facility, i.e. Go signal will be
cancelled if passage through GlasStile is not completed within pre-set
time. The standard default is 15 seconds adjustable via the hand held
programmer.
Power Supply
:
115/230 Volts AC 50/60 Hz
Power Rating
:
80 VA per Walkway
Logic Voltage
:
24 Volt DC
Installation Details
:
GlasStile GLS range is delivered kit form i.e. Wings, Casework and
Rotor, which may require lifting gear for off loading.
Approximate weight 170 kg
Product Description
The award winning
GlasStile from our
Regulate range is
designed to offer many
material options including
wood, marble, slate,
stainless steel handrails
and glass casework.
The personalisation
ensures total integration
into any environment,
whilst operating quietly
and rapidly.
Users include
•
Government
•
Retail
•
Finance
•
Telecommunications
•
Information
Technology
•
Banking
•
Publishing
•
Leisure
•
Petrochemical
•
Education
Product Data Sheet
ISO 9001
FM 13503
Regulate

ปปาณ
……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
2
Installation Examples
Models Available
GlasStile Motorised Entrance Gate
•
Model GLS1350A
1350 dia. - constructed from 63mm dia. uprights and 38mm dia curved handrail affixed via concealed fixings.
•
Model GLS1500A
1500 dia. - constructed from 63mm dia. uprights with 38mm dia curved handrail affixed via concealed fixings.
•
Model GLS1350B
1350 dia. - constructed from 50mm dia. formed and welded tube.
•
Model GLS1500B
1500 dia. - constructed from 50mm dia. formed and welded tube.
•
Model GLS1350D
1350 dia. – constructed from 63 dia tube, 10mm curved glass and handrail option (see below)
•
Model GLS1500D
1500 dia. - constructed from 63 dia tube, 10mm curved glass and handrail option (see below)
Standard Materials
Rotor cladding and casework material choice
•
304 Grade Polished Stainless Steel, Ref: GM Type 3
•
304 Grade Grained Stainless Steel, Ref: GM Type 2
•
CZ108 Polished Brass
•
CZ108 Grained Brass
Handrail Material and Aesthetic Options
(Please consult Gunnebo Mayor for details)
•
Stainless Steel
•
Choice of natural material, i.e. Wood, Marble, Granite etc
•
Chicane, Chevron or custom profile.
Standard Accessories and Optional Extras
Alternative Materials, Finishes and Custom Design
•
Refer to Gunnebo Mayor for specific material design requirements.
Cardreader Mounting
(Please refer to Gunnebo Mayor for feasibility)
•
Integration of customer supplied readers into the handrail.
•
Integration of customer supplied readers onto the casework uprights.
•
Cardreader Pedestals.
Battery Back Up System
.
•
Maintains all 24V control facilities for 500 operations or 4 hours whichever the sooner. Remotely located.
Push Button Control
•
Simple console to control GlasStile rotor release.
•
Remote console to specific requirements
•
Singular tubular casework mounted push button
Hand held programmer
•
Required to set up new installations.
Push bar
•
Affixed to the top of each glass wing to match casework choice.
Chevron
Chicane

ปปาณ
……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
3
Site Preparation GlasStile Type A Casework
IMPORTANT
•
Floor Anchors to be drilled during installation, 12mm dia. x 100mm deep.
•
Any horizontal pipe or conduit runs below the GlasStile must be at least 140mm below
Concrete to BS 5328: 1997 specification, type ST5.
Base to be flat and level to +/-5mm over footprint area.
Rotor Column Base min 300 x 300 x 300mm
Motorised Rotor Column
10mm clear toughened Glass Wings
38mm dia. Stainless Steel Handrail
63mm dia. Stainless Steel Uprights

ปปาณ
……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
4
Site Preparation GlasStile Type B Casework
IMPORTANT
•
Floor Anchors to be drilled during installation, 12mm dia. x 100mm deep.
•
Any horizontal pipe or conduit runs below the GlasStile must be at least 140mm below
50mm dia. Stainless Steel Handrail
Motorised Rotor Column
10mm clear toughened Glass Wings
Concrete to BS 5328: 1997 specification, type ST5.
Base to be flat and level to +/-5mm over footprint area.
Rotor Column Base min 300 x 300 x 300mm

ปปาณ
……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
5
Site Preparation GlasStile Type D Casework
IMPORTANT
•
Floor Anchors to be drilled during installation, 12mm dia. x 100mm deep.
•
Any horizontal pipe or conduit runs below the GlasStile must be at least 140mm below
10mm clear toughened Glass Wings
Concrete to BS 5328: 1997 specification, type ST5.
Base to be flat and level to +/-5mm over footprint area.
Rotor Column Base min 300 x 300 x 300mm
Motorised Rotor Column
Handrail option (Chevron shown)
10mm curved Toughened Glass
Card Reader integration into the Handrail
(Option)

ปปาณ
……………………………………………………………….
PDS/GlasStile/Issue 1 02.01
6
Note: In pursuit of its policy of continuous refinement and improvement, Gunnebo Mayor Ltd. reserves the right to modify design and details.
A COMPANY WITHIN THE GUNNEBO GROUP
……………………………………………………………………………………………………
Flow Rates
Reader Device
Number per minute
Insertion type
20
Insertion type with PIN code keypad
10
Swipe type
30
Swipe type with PIN code keypad
12
Proximity ‘Hands Free’
35
•
Please note the figures are approximate and must be confirmed with Gunnebo Mayor Ltd.
Figures quoted are for one person per complete passage per walkway and per minute.
It is assumed the access control authorisation response is instantaneous.
Flow rates will increase with multiple passage use.
United Kingdom
Gunnebo Mayor Ltd. Bellbrook Business Park, Uckfield, East Sussex, TN22 lQQ.
Tel +44 (0) 1825 761022
Fax +44 (0) 1825 763835
Gunnebo Mayor Ltd. Orient House, Newton Street, Hyde, Cheshire, SK14
4RX
Tel +44 (0) 161 882 5900 Fax +44 (0) 161 882 5910
www.gunnebomayor.com
GERMANY
Gunnebo Entrance Control GmbH
Diagonalstrasse 41, D-20537
Hamburg
Tel
+49 (0) 40 47 11 30 0
Fax
+49 (0) 40 47 11 30 79
SPAIN
Gunnebo Entrance Control
BBC, Comte d’Urgel 143, Iola 08036,
Barcelona
Tel
+34 93 452 59 56
Fax
+34 93 451 56 53
DENMARK
Gunnebo Protection A/S
Division Entrance Control
Erhvervsparken 3, DK-4621 Gadstrup
Tel
+45 46 19 14 66
Fax
+45 46 19 14 55
ITALY
Gunnebo Italdis SpA
Via A Volta 15 - IT 38015
Lavis (TN)
Tel
+39 0461 248 900
Fax
+39 0461 248 999
UNITED KINGDOM
Gunnebo Mayor Ltd
Bellbrook Business Park, Uckfield,
East Sussex, TN22 lQQ
Tel
+44 (0) 1825 761022
Fax
+44 (0) 1825 763835
HEAD OFFICE SWEDEN –Gunnebo Entrance Control AB, SE-590 93, Gunnebo.
Tel +46 (0) 490 89000, Fax +46 (0) 490 23889
FRANCE
Gunnebo Entrance Control SARL
Zone d’Activites Le Mandinet,
20 Rue des Campanules
F-77185, Lognes
Tel
+33 (0) 1 64 80 14 40
Fax
+33 (0) 1 64 80 14 39
NORWAY
Gunnebo Troax A/S
Division Entrance Control
Postboks 179, Kalbakken N-0903, Oslo
Tel.
+47 22 80 42 00
Fax
+47 22 80 42 01
USA
Gunnebo Omega Inc
5056 Commercial Circle, Suite E,
Concord, California, CA 94520
Tel
+01 925 609 6339
Fax
+019256030810
HONG KONG
Gunnebo Entrance Control
Room 2312, C.C. Wu Building,
302-308 Hennessy Road, Wanchai.
Tel
+852 2882 8337
Fax
+852 2523 7880
SWEDEN
Gunnebo Entrance Control
Box 500, Kumla Gardsvag 33F, 145 63
Norsborg
Tel
+46 (0)8 53 17 15 75
Fax
+46 (0) 8 53 18 85 39

ปปาณ